Posted by Mark (IP: 161.160.61.41) on April 01, 1999 at 07:24:29:
In Reply to: Re: I think there are differences posted by Brandon on April 01, 1999 at 02:20:31:
Take the entire dash board. Bolts on the sides two on each
I think and there are screws close to the windshield. If
you can afford it, I take the steering column and the wiring
harness. When you have the dash out of a Mav you had beter
check your harness for shorts and such. the big prob is
getting the dash out of your car while the windsheild is in.
It can be done but you need a small philllups on some kind of
ratchet. we rigged a drummel with the flexable end to get
the job done.
The seats are easy. You have buckets now right? Take off the
passenger side seat. and then remove the bracket that holds the seat to the
floor. on a piece of poster board trace the pattern that bolts to the
bottom of the seat. That bolt patter will match most small fords with single
adjustment bucket seats made before 1980. It will fit others with two way
adjustments but I can't remember which ones andway look for Mustang II
buckets they should be perfect for your application. You bolt your new black
buckets to the old brackets and then you don't have to worry about drilling new
holes in you floor or positioning them right or anything.... dang easy.