Posted by T.L. (IP: 206.133.171.76) on September 15, 1999 at 22:02:42:
In Reply to: Get a new floor shifter posted by Mark on September 15, 1999 at 12:26:25:
: I have a B&M that is cable driven. There is a small hole that needs to be cut to allow the cable to run through, but you don't have to worry with any linkage besides the actual brackets to the tranny. Those should come with the new shifter. This is pretty much the easiest way to get headers to fit too.
: : I'm new the the message broad. but I'm need help I'm putting a 302 in
: : my maverick that use to have a 200 in will the old shift linkage fit
: : or do I need New stuff? Where can I get the new stuff? PLease help.
: : Thank you in advance
: : MG