Hi-Po 289


[ Follow Ups ] [ Post Followup ] [ Maverick Message Board ] [ FAQ ]

Posted by Craig Selvey (IP: 208.31.244.204) on September 18, 1999 at 08:38:30:

In Reply to: GOT IT!!!! posted by Brian on September 16, 1999 at 23:52:47:

To see if you have a 289 Hi-Po (K-Code Engine on a Mustang/Fairlane, etc) head.....where it says 289 on the head under the valve cover...look for two "dots" over the 289. These would be Hi-Po heads.

This is all I know...read it in Mustangs and Fords.

==============================================================
: Went and picked up the '67 289 today. Paid $50.00 for it. Have the block
: sold already. Actually traded it for a fresh AOD tranny. One of the heads
: has me concerned though. One of the outside cylinders has lots of corrosion
: on the combustion chamber.As if it had a blown head gasket (optimistic)
: or a crack (my luck). Whatever it is I hope it can be fixed. The other seven chambers
: look great. The heads have "289" stamped on one side and "66" stamped on the other
: and the casting number appears to be "7A20." If anyone has any insight on old Ford
: heads, could you please give me an idea as to what they came out of? Out of
: curiosity mostly...

: Thanks, Brian.

: P.S. I'd like to thank everyone for there ideas and suggestions over the last few
: days. It was greatly appreciated.




Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Maverick Message Board ] [ FAQ ]