Posted by rickyracer (IP: 209.20.173.123) on September 25, 1999 at 17:04:33:
In Reply to: Tranny gasket posted by Brandon on September 25, 1999 at 16:51:26:
: use some silcone sealer around the edges. fluid is C-3 & C-4 through 1979 is Type F, 1980 and later is Dexron II or III
I replaced the transmission pan gasket about 3-4 months ago and its been leaking a little bit ever since. In the last few days it started leaking really bad so I bough another gasket and I'll replace it tomorrow. I hate the stupid cork gaskets but that's all these places seem to have around here. How can I make it not leak this time? Last time I cleaned both surfaces very well and used a small amound of sealant. I tightened the bolts so that the gasket just started squeazing out a little bit. When I saw that it was leaking, I tightened them down a little more. I don't want to have to do this again so any advice is welcome. BTW, is it ok to use the Dextron III or whatever they have now? Parts store said it was ok.