Posted by Mavman (IP: 192.62.107.213) on September 28, 1999 at 10:49:32:
In Reply to: Well.... posted by Mavman on September 28, 1999 at 10:44:22:
I suggested the 3" in place of the dual 2.25" pipes. One 3" should fit alot better in the six tranny mount than two 2.25" pipes. If you think about the flow of six cylinders into 4.5" combined pipe diameter, isn't that a little more overkill that one 3"???
"The duals will fit fine down the same side - don't go overboard on pipe diameter - 2.25" max. They won't exactly fit the cutout in the crossmember".
: : ...The dual is the trick setup. The single is a little quieter & retains bottom end power. I think 3" is too big for a single - 2.5" would be max. After all does anyone one use 3" pipes on a dual exhaust for a 400ci v8?
: : : ...using a 3 inch pipe from the header, and into a single in/dual out muffler. Just a question. I guess that the header(s) is split as well, so you would have to have two pipes, right???