Posted by TBR on November 17, 1998 at 18:05:15:
In Reply to: Crossflow heads for I6 posted by Terry R on September 23, 1998 at 08:20:41:
>>> Sid, I am no longer at the old address where I posted the previous note. You can get me at reegs2rnr@aol.com. I can't get any messages you sent since 11/11. Your bud, TBR
: I posted this a long time ago on the old site: Does anyone have info on how to get the Australian cylinder head for the 3.3L six? It is an aluminum, cross-flow design. It also uses 351C valve train. I read years ago that is was a hot setup! I need the intake & exhaust manifolds to go with it (forget the exhaust if the US manifold will work - i don't want to scrap my header).