Posted by Mike on December 28, 1998 at 11:48:06:
In Reply to: headder for a straight six posted by Blackfoot Willie on December 28, 1998 at 09:57:20:
Check out Clifford Research in Corona CA. I had a set of their headers when I had my 200 in my car. The only problem that I had was blowing the gasket around 3&4 exhaust port. They tend to hang down a little. If your car isn't to low you should be fine
Have Fun
: Yo!
: Looking for information on obtaining a header for
: my 250c.i. inline six cylinder motor.
: This is to a 1976 Maverick(I also have a 1975
: Maverick with a 302).
: Anybody know where I can purchase one?
:
: Blackfoot Willie check out one of my sites...
: http://www.cyberlodg.com/yep/