Posted by Walter on September 17, 1998 at 21:58:15:
In Reply to: Re: Small block C6?(edited) posted by Craig Selvey on September 12, 1998 at 22:36:25:
: The C-6 will work........if you want to cut out your transmission hump out of the floor to make it larger. Then you need to move the cross-member mounting spots back. Alot of work to do it "Right". Stick with rebuilding the C-4.
I put theC6 in my 72 comet. all it took was one hammer wack to clearance the hump and a 67-68 mustang cross member add a spacer as the comet crossmember is skinner and bolt it up. I also hesitated as everyone said it was so difficult. But I asked a professional race trans builder for advice and his advice was exactly on target.
: ===============================================
: : Today my Mav's tranny decided to leak from everywhere possible. I've been putting off a rebuild but I guess now it's time. I was wondering if a small block C6 will bolt in where my C4 is.