Posted by tom (IP: 152.163.204.78) on December 14, 1999 at 20:15:08:
In Reply to: Re: 4 Wheel alignment posted by rickyracer on December 14, 1999 at 19:20:30:
: :piece of cake, requires two people and a 25ft steel tape measure.
: first; measure your front to rear wheel lengths RF to RR, LF to LR, shouldn't be move then 1/2". use the spindle on the fronts and the axle hub on the rears for the measurement, make sure your wheels are straight ahead.
: second; measure in a X pattern the distance from RF to LR and then LF to RR using the lower ball joints as a reference in the front and as far out on the rear of the housing as possible. This should also be less the 1/2".
:
: you can move the rear housing to make the measurements as close as possible. the closer the better.
:
: How is this done? Can i check it on my own, or does it have to go to the alignment shop? Thanx
: : Mark G