Posted by Charlie (IP: 131.204.83.102) on December 04, 1999 at 15:06:17:
In Reply to: "Z" Bar... posted by Mavman on December 03, 1999 at 14:45:56:
From a 65 (Maybe same through '68?) bar. Had to cut the bottom part off and reweld at another angle. Also had to shorten the "tube" part some. It slides right in, through headers and all, even though it is one piece. I've located a V8 stick Maverick and will be removing it's bar and putting all that linkage in my car though, because I've been having problems adjusting my clutch. It can be done, though, and I've put 30k on the thing with basically no problems, (It's probably ME abusing those clutches, hehe.) I am going back stock though -CP
: Dumb question that I know has been covered, but can a Mustang "Z" bar be used on a Maverick? Charlie Ping gave me a the link below, and they show several "Equalizer bars" for the Mustangs. It also has alot on the bushings...