Posted by Charlie (IP: 131.204.141.66) on February 22, 2000 at 23:05:43:
In Reply to: Charlie P... posted by Russ on February 22, 2000 at 21:45:52:
I don't know the #'s for the shims, almost certainly they are unavailable. I could measure mine, but I would recommend just cutting off the mounts and re-welding them at the proper angle. I think I will do this to my car eventually. it wouldn't be difficult, and would keep from spacing the rearend up in to car.
The Bronco chunk probably is 31 spline. You can check it to make sure. If so it will not work, as the Versailles is 28 spline. -CP
: Charlie I have come across a Versalis rear. Its already out of the car and has the parts in bucket. Before I buy this thing I have some questions. I believe the wedges(shims) for the springs are missing. Do you have a part number for them? If they are even available. If not do you know the measurments of them? I'm a machinist so I could make some if I knew what they measured. Also I have a 9" center section out of '79 Bronco with 3.50 gears. Do you think this would work with the Versallies axles? Thanks Russ