Posted by 74merc (IP: 207.157.60.18) on June 09, 2000 at 01:13:35:
In Reply to: will do, but... posted by 74merc on June 07, 2000 at 17:51:05:
: it'll be awhile before I can get pics of the tranny in the car... I'll use my boss's digital camera for that cuz I don't think my little 35mm camera will be able to focus from such a close distance. I'll put it on a lift after I get finished and take a few more pics... I'll guarantee, its tight, no room for anything else in there...
: The drive shaft needed no modifications whatsoever, just slipped right in. The top bellhousing bolts were pretty interesting, there isn't enough space to put them in if the engine is sitting correctly, I had to bolt up the four bottom bolts and let the jack down under the tranny to tilt the engine so the bolt could fit below a ridge in the firewall, at normal height, I don't think its possible to get the bolts in. A note here, you may want to put in the top bellhousing bolts before you get the tranny lined up and in there, have them in the bellhousing before the tranny lines up... PITA...
: overall, I think it is gonna work out fine...
:
: : : in and running. Only problem is my C4 linkage is on the bottom of the shaft, the AOD has it on top. it reversed my shifting pattern. How do I get it off to flip it over? I can get off the TV linkage, but I couldn't move the shift linkage and I don't want to break it.
: : : gracias
: : : ps: I got the pics requested, just have to develop and scan...
: : Don't forget to send me some pics of the install!!!