Well I got a 78 Versailles...

[ Follow Ups ] [ Post Followup ] [ Maverick Message Board ] [ FAQ ]

Posted by Mark G (IP: 205.188.192.171) on March 26, 2000 at 20:00:26:

Now my question is weather I can use a bronco 3rd member in the 9". I know that broncos are 31 spline axles. If I use some aftermarket 31 spline axles and the bronco center, will that work? What else do I need, does the bronco pumpkin yoke bolt up to a mustang drive shaft, I assume that I will also have to shorten my drive shaft. This 9" is going in a 65 stang by the way, but the front discs are going on the mav! So what else on the versailles could I possibly use on the mav? Is a 78 302 block any good, i figure the heads are junk, but maybe the shortblock with some aftermarket heads would work. To low compression? If anyone needs any Versailles parts, this one is super clean even the clock works, to bad its so ugly! Thanx for the help guys!

Mark G

Follow Ups:

Post a Followup

Name:
E-Mail:

Subject:

Comments:
: Now my question is weather I can use a bronco 3rd member in the 9". I know that broncos are 31 spline axles. If I use some aftermarket 31 spline axles and the bronco center, will that work? What else do I need, does the bronco pumpkin yoke bolt up to a mustang drive shaft, I assume that I will also have to shorten my drive shaft. This 9" is going in a 65 stang by the way, but the front discs are going on the mav! So what else on the versailles could I possibly use on the mav? Is a 78 302 block any good, i figure the heads are junk, but maybe the shortblock with some aftermarket heads would work. To low compression? If anyone needs any Versailles parts, this one is super clean even the clock works, to bad its so ugly! Thanx for the help guys! : Mark G

Optional Link URL:
Link Title:
Optional Image URL:

[ Follow Ups ] [ Post Followup ] [ Maverick Message Board ] [ FAQ ]