Posted by David Blodgett (IP: 128.118.248.18) on November 01, 1999 at 19:10:49:
In Reply to: What the...... posted by Craig Selvey on November 01, 1999 at 17:54:56:
you have to make sure the notch on the converter engages inside the trans...
: It is impossible to get the tranny back on the engine with the converter still bolted to the flywheel. Take the converter off of the flywheel and put it on the tranny (all the way), then put the tranny in.
:
: ==================================
: : Help , the auto trans from the 8 won't set into the 6 , Swapped the bells and the converters were not removed from the engines. what to do?
: : The tranny is about an inch from being stabbed all the way into the 6 but it wont go in to bolt up to the engine. Tried turning the driveshaft, wiggling , brut force, and still nothing gets it closer. swap drveshafts? drop the converter? scrap the project? or hey what's next?