Posted by TParker (IP: 4.33.1.93) on November 09, 1999 at 17:13:22:
In Reply to: Rear Spoiler Installation Question.....? posted by Jay..... on November 09, 1999 at 16:40:59:
Ok! I just went out and measured my factory one, it is centered on the curve. There are 4 bolts sticking threw, 2 on the ends and 2 in the middle. The end ones are 8.5" in from the ends of the deck lid. The Middle ones are 10.5" in from the end ones. I have heard that this takes a 1" hole to install them. Hope this helps.
: I just picked up a rear spoiler for the Mav and, well, the end caps went on easy enough. The question is how and/or where do you drill the holes for the spoiler...??? I would hate to mess it up concidering that you only get one chance at it and then your screwed.
: Is there a template or measurements that you can follow to do this job correctly. Thanks in advance, Jay.....