Posted by TBR (IP: 152.163.206.188) on November 16, 1999 at 09:36:14:
In Reply to: Re: I did it... posted by Mark G on November 15, 1999 at 18:35:27:
...I kept the stock springs (it's a 200 six/4-speed), added ADDCO 1 1/8" front sway bar & 7/8" rear bar(Mustang bars are too wide), Gabriel Red Ryders up front & Hi-jackers in back (contrary to other opinions posed on this board, the first set lasted over 100k miles). The negative wedge kit is what you need to correct the ball joint angle. I fabricated my own. Pain in the ass, but this was before the kit went on the market. I also had the front eye on the leaf spings reverse wound - that lowered the rear & correct the roll steer built into the stock setup. If I were to do it over, I would have stiffened the front springs a bit (possibly cut a coil) and gone with smaller bars. The ones I have are great, but make for a stiff ride on single wheel bumps;-)