Posted by mustang (IP: 216.180.26.67) on November 17, 1999 at 22:04:31:
In Reply to: I have a 2.79 behind my 289 posted by Mavman on November 16, 1999 at 09:13:06:
go with some 4.10's that will give you the nice take off power you need..hehe..88 stang/t-5/4:10's..
: It loves 80!!! I have my 3.40 gear, but haven't installed it. It bogs a little on HARD take-offs, but runs great after that.
: : This letter is a cry for part numbers and an offer to buy some of the bits and pieces that some of you may have.
: : I have been working on this four door Maverick for the last year and it is all coming together. Instead of re-building the 250 CID six, I have elected to install a 302. I've got a good price on a NEW engine from a local engine rebuilder in Scottsdale AZ. About $1200.00 for a long block, with all new parts. What are the correct part numbers for motor mounts?
: : How about front and rear springs?
: : I am told that a correct C4 transmission is slightly differant for the 302. Is this true?
: : The rear axle is I beleive around 2.79 to one and is eight inch diameter. This is a fine ratio for a freeway crueiser.
: : My suspension is all brand new (every part). Tires are new 195-70-14 Goodyear Eagle GTII's.
: : I will also need part numbers for accessory brackets for the engine (power steering, alternator, and air conditionilg).
: : I have a V8 radiator available for the swap.
: : I have not settled on intake components (carb and manifold and optimum cam). I also have not decided on headers or stock cast manifold. This comes later as I gather all the parts.
: :
: : Thanks for any suggestions