Posted by Dennis (IP: 205.188.199.22) on November 30, 1999 at 06:18:05:
In Reply to: OK but just one last one. RE: bucket seat retro fit. posted by Mavdude on November 30, 1999 at 00:41:03:
Anything will fit if you want it to. You will just have to modify the mounts or make new ones. Sometimes its easier to modify the Maverick mounts to fit the new seats. Sometimes you can do a combination of both. The only consideration is the width. As long as they fit in between the doors (closed of course)it can be done. As far as wiring, if the controls are all on the seat all you should need is a switched 12v line. If they are mounted elsewhere then you will need all the wiring harnesses between the switch(s) & the seat. good luck, sounds like an interesting swap.