Posted by Chris S (IP: 129.255.150.94) on December 24, 2000 at 20:24:54:
In Reply to: Re: roll bars posted by T Stone on December 24, 2000 at 20:09:23:
: Chris,
: I went with a S&W 10 point. I was very pleased with it. I had to do some minor trimming and fitting, but that was because of the way that I ran my bars, not because of the kit itself. I said at the time that if I were only installing a 6 or 8 point cage, the only thing that I would have had to do would have been to cut off a little bit of the uprights of the main hoop for the specific clearance that I wanted. The kit arrived on time, and with all of the pieces. And I can't complain about the price. Just my 2 cents.
: : hi, just curious as to what the general preferences are with roll bar brands? between S&W,chassis engineering,alston,and jegs? anybody have a favorite as far as fit and finish?thanks
I had a chassis engineering 8 point in my last car which wasnt too bad, but I'm thinking of going with a different brand this next time. how was the fit around the seats with the S&W?