Posted by T.L. (IP: 38.27.205.55) on November 19, 2000 at 12:41:40:
In Reply to: Re: manual disc brakes posted by mavman on November 16, 2000 at 23:07:58:
Even if you did not swap the prop. valve, that would not make it hard to stop...the OMLY THING the prop. valve does is: reduce rear-wheel lockup...You should STILL check to make sure you hooked the lines up properly & didn't get them switched...
: Did you swap the proportioning valve also? If not that may be your problem. If you did ,is it possible that the valve is bad? Or maybe
: : some part of the system got some trash in it and that and is causing your problem? After checking these things,My next step would be to replace the Master cylinder with a New one and see what happens
: : M.A.V.
: yes, I swapped the bias valve as well, it came off of the granada. It is still possible that there is some trash in the system, but I am going to buy a new m/c tomorrow (only $19). hopefully that will help.