Posted by Steve-S (IP: 24.93.48.154) on November 02, 2000 at 20:28:22:
In Reply to: Re: Rings, & Main, Rod bearings. Tips????? posted by MadMav71 on November 02, 2000 at 20:22:05:
I was thinking of using some rubber hose or whatever similar I have to fit. My Torque wrench is of the type that you set by rotating the handle & then it will click when it reaches that torque. I HOPE it is calibrated properly, but have no way of verifying that. Will I need to remove the head? Can I put the pistons back in from the bottom?
Steve-S
: Just be very careful and you should be okay. You can also use short lengths of vaccuum hose or whatever you have laying around that will fit, if you feel it is necessary. Just keep everything good and clean and make sure you have a good torque wrench!