Posted by #88 (IP: 63.16.115.197) on October 29, 2000 at 09:07:43:
In Reply to: Re: Remember this is a 69.5---would a 70 to + v8 crossmember fit? posted by Fastman on October 28, 2000 at 02:07:41:
: Yes, the V8 crossmember has a certain bend to it. It bends upwards on both sides equally unlike the 6 cyl. where that one has the bend up on one side and is straight on the other. The curves or bends on both sides allows for a dual exhaust because the piping can then be routed through this area without going at a downward bend then back up to clear the 6 cyl. crossmember(that would cause clearance problems). My advice is still to get the V8 crossmember, when you see it, you'll see the difference. Sorry, but my explaination may not be that good.
thats what i been wondering...not raising or lowering it??