Posted by Fastman (IP: 209.179.229.68) on October 23, 2000 at 22:04:24:
In Reply to: Opinions on headers and shifters... posted by Inshan on October 23, 2000 at 09:01:54:
I am using those headers, and I am using a 68 Mustang floor shifter for my C4. Cutting the hole was kinda tricky, but the hardest part was getting the shifter rod to fit, I had to bend mine a little to fit through the trans. crossmember area. Like I've said before, I don't have P/S so installing the headers wasn't a problem. They went right in in about 20 minutes for both sides WITHOUT lifting the engine(from under the car of course). If I had the money at the time I would have gotten an aftermarket floor shifter though, one with a cable is better than the rod.