Posted by Steve-S (IP: 24.27.9.79) on September 02, 2000 at 18:27:09:
Please Help Me!
I've replaced the turn signal cog in my steering column twice. First time one of the contact wires on the backside was too long to fit into that area so I clipped it a little. When I was done my left turn signal would produce flashing on the front & both left side lights but not the left rear. Whereas the right would only flash the rear and not the side or front. The internal indicators would flash for a right turn but not a left turn. I replaced it again, w/o clipping anything, and now the problem is swapped left to right. There is a bit of grease in there and I'm wondering if it's supposed to be there. Is it making or preventing the contacts??? I've run out of ideas as to what is causing this. Please Help.
Thank You
Steve-S