Posted by: Dan Starnes ®
2001/08/25, 18:38:55
Author Profile
|
John, While messing with a C6 today I found this info for adjusting c4 bands. intermediate band goes as such, Clean all dirt from the adjusting screw and remove and discard the the old locknut. Using a new locknut on the adjusting screw, tighten using a torque wrench @ 10 ft. lbs. Back off the adjusting screw exactly 1-1/3 turns. Then hold the adjusting screw steady and tighten the locknut. for the low-reverse band, its all basically the same except you back off the adjusting screw 3 turns. the tighten the locknut to the proper torque, which I think is 10 ft. lbs. hope this helps! Dan :How do you tighten up the bands? I read about it before but I can not remember.(getting old)
|