:Handshake...as you see, this started out...a quarter panel repair finishing project. turned into a...quarter panel repair (redo), tailpanel strip/prime, refinish gravel pan, sand/prep quarter tips, rework/patch/prime spoiler and block sand trunk lid... been a busy 6-7 days... will have it together today and ready for our meet tomorrow...
Nice job Frank. All those lites/sections illuminated or just outsides? What color will the car be or have u decided yet? That lighting seup is a great combo on these cars .. Probably be the only one's I'd consider to replace a Comets lites
...:Handshake... car will never be one color... I installed a set of lights in the inside lens...4 when braking, 2 each side for turn and 4 running.
Frank, very nice ! ! ! How did you wire your rear lights ? I put the other 2 bulbs in and everything works together. Are your inside bulbs single filment ? If you would draw me a diagram. Thanks Rick
Great job there Frank!!!!! Do you have much body work experience? I'm not looking forward to it but someones got to do it!
duel filament bulb sockets...wired in with the running/turn signal wires from the other lights. hope this helps.
no experience..I have a few body shop Guys that coach me and sometimes do certain fiberglass repair jobs for me. not hard, time consuming and a lot of stuff that has to be mixed and prepped correctly.
Frank. I was looking and couldn't find any threads about your shop. Curious how high you had to build it to have that rack..
