Separate names with a comma.
I have one '77 Mav 4 dr with a 302 That's 828
If the cam is ground for a 351, I'm screwed. I'll call Edelbrock with their part number in the morning. Thanks for all your help. You guys are...
Thanks guys. I bought a 1 ohm resistor at Radio Shack, and installed it per my wiring diagram. I thought that was the reason it wouldn't start,...
Steven, do you have any idea where I could get a replacement wire for the "resistor wire? Ford? Autozone? Napa?
Is it the coil-to-distributor wire, or one of the wires to the two small terminals? If it's the coil-to-distributor wire, is it available at...
My 77 Mav coil has "for use with external resistor only" printed on it. So where is the resistor? I see no physical attachment. What am I missing?
I've still got one! My '77 4 dr = 274
Thanks for a great answer! I ordered a high volume oil pump at an early point in the rebuild of my 77 302, thinking it would reduce the amount of...
I'm putting a Melling high volume (+25%) oil pump in my 302, and wondered why that causes Dist gear problems. You've got me worried. I'm still...
Once again you folks come though! Thanks. Hey Dave, how do I check the springs? Do I have to remove them from the head, or tested "in place"? I...
No cracks, no chips, but some scum on the inside drivers side. I tried to rub it out, but didn't have the right stuff. Windex didn't cut it. I'll...
I got the 302 and C-4 out over the weekend, and taking my time overhauling the motor. Are all rockers identical, or is there a difference...
Corbin, this is a nice car, with no body rust, clean interior, and all the rubber products have been replaced (no dry-rot). Car has 55K on it, and...
I've decided to either sell my 77 Mav outright, or part it out. I've ordered a FFR Cobra kit, and very tempted to pull the engine (302) and tranny...
I just took off a set of stock exhaust manifolds from my 77 302. Give me an offer I can't refuse. One or both? Grant
Thanks Mavaholic, I have pretty well eliminated this as a possibility. I talked to a ford tech guy, and found out that the 351M was designed...
Hey guys, it's a 351M with a 4v carb. Is there a website I can look up the physical dimensions of this motor? The height of the motor is...
The search button is a great place to start. The cummulative knowledge of this forum is a great resource. I started looking for sources like you...
I used a 1/4" nut driver to slightly rotate the pump shaft. Move this slightly, try again, etc, etc. Keep doing this until the distributor drops...
Thanks again! You folks are the best! Some great ideas here. Maybe someone else will benefit from your answers too. If anyone else has...
