Separate names with a comma.
Thanks for the reply. By chance do you remember the name of the company that you used? Chuck
I need my anodized aluminum (rear window trim & tail light bezels) polished and was wondering if there was anybody on the forum that did that...
I found this at my local Walmart yesterday. I looked but did not find anything about it on here, just wondering if anyone else has seen them....
I went to the RockAuto site and they have a service that will rebuild yours. They have a pretty quick turn around, reasonable cost, and it will...
I had mine rebuilt through Rockauto about 2 months ago, I believe the company that rebuilt it is out of Texas. They have a pretty fast turn around...
Thanks Craig, that is exactly what I needed. :)
I'm Looking for pictures of a 76 stallion's e-brake routing, The floor pans were replaced and not sure if all of the brackets were reattach. The...
I'm not sure but I think you will run into problems around the bell housing area if you are using gt40-p heads, I believe the p heads have higher...
Welcome back, good to see you again.
My caliper was making contact with the wheel near the mounting surface so I had to push it out just a bit. Where is your caliper making contact...
I had the same problem with my Sprint when I converted to 4 wheel disk, I got some 1/4" spacers and that fixed the problem and did not push the...
I have a connection just like that on my 74 Comet that goes to my electric choke, there is a wire that goes from the choke to that connection.
Thanks Eric, That's just what I needed.
Eric, thanks for the info.
Eric when you say ignition wire is that the big yellow wire going through the fire wall? Do you by chance have a picture of how you wired the...
I am looking for a switched power source under the hood that becomes hot with the switch and stays hot during cranking, and it needs to stay above...
No mine is not a Cali car. Since I can't find a inline charcoal filter I guess I will run a line up to the front and add a charcoal canister, it...
Mine is a 70, no tank vent and no charcoal canister under the hood.
I am in the process of installing a Fitech fuel injection system on my 70 Mav and I was wondering where I should run the tank vent. I am still...
I use Easy-off oven cleaner and a pressure-washer. Just spray it down let it set for about 30min then hit with a pressure-washer.
