Separate names with a comma.
There is only one way to make sure a MSD ignition don't spoil your race day, that is to make sure it isn't in your car.
if you granny Shift you can do it with a pair of Vise grips, it don't matter what kind of shifter you use!
About powershifting a T5 I run a 1978 Mustang Cobra II with a 302 and a T5 that has a Counter shaft support plate and a good Shifter. this...
I agree with you on the C6 head castings I have two sets and both Came with a 1.78 intake and 1.45 exhaust. the numbers must be California heads!
I owned a 1971 Maverick Grabber and a 1974 Comet GT. The 1971 was a ruster and the 1974 was sound! I all ways liked the look of the front of...
I don't think there are vary many racers that haven't experienced the Runner up in the First round! What I have found is some Sundays I just...
The early Models are easy to tell a 1969.5 has the Key in the dash but still has 1970 on the Registration! The true 1970 had a locking...
Ok thanks I was running a set of World Windsor's out of the box, I was never real pleased with them, Good to hear of good performance with the...
I was just wondering if any body has tried a 347 with 205 AFR heads. My Cam is a .600 lift with 254 duration at .050" 294 advertised...
The only time a Converter would effect the RPM during a gear change would be if the Converter was So loose that it is slipping during gear...
Your converter stall speed has nothing to do with how far the RPM drops between gears, This would be caused by transmission gear spacing....
and were do you smart ass 's get a new stock replacement for less? I was quoted 279. 99 for a new ford stock Flywheel.
if you need to buy a new Flywheel I just Bought a new safety certified PRW Flywheel for 265.00 and it has the removable Weight so it can be...
The 8.8 does turn easier than a 9' but as for the being as strong depends on what 8.8 and what 9 inch! A 9" rear can be built to handle a top...
The hood mounted tach was a Pontiac thing and it looks out of place on any thing but a Firebird of a GTO!
The reason the 9 inch takes more power to turn is because of the low pinion Angle. This causes a bad angle on the gears Because the 9" is the...
That they rate for stall speed is with the transmission in gear at idle floor the throttle and the RPM will flash to a point before it...
I agree with you Mav Man Some of the so call big names build the worst Converters I had a TCI 3000 That Was still slipping at 6000 RPM! I lost...
A 1.48 60 ft time is hooking hard your doing something right!
