Ignition Problems

Discussion in 'Technical' started by wyliedx, Jul 27, 2011.

  1. wyliedx

    wyliedx Member

    Joined:
    Jul 26, 2008
    Messages:
    32
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Afghanistan
    Vehicle:
    maverick
    I have a 77 Maverick with a 302. I just installed a 6AL Ignition Control, distributor, blaster 2 coil, and MSD spark plug wire. When I turn the car over it starts, but as soon as release the key, the car stops. As long as the starter stays engaged, the car runs, but as soon as the starter disengage the car shuts off.

    Any help would be nice before I call MSD.

    Thanks
     
    wyliedx, Jul 27, 2011
    #1
  2. Mavman72

    Mavman72 Gone backwards but lookin' forward

    Joined:
    Apr 24, 2007
    Messages:
    6,759
    Likes Received:
    272
    Trophy Points:
    273
    Location:
    Buffalo N.Y.
    Vehicle:
    1972 Maverick 2 door.Original V-8 3 spd std shift.Also a 72 one owner Sprint sporting a 351 Windsor
    You hooked your coil to the start wire instead of the run wire off the ignition switch...Or you hooked the switch wire for the MSD to the start wire instead of the run wire off the ignition switch...
     
    Mavman72, Jul 27, 2011
    #2
  3. wyliedx

    wyliedx Member

    Joined:
    Jul 26, 2008
    Messages:
    32
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Afghanistan
    Vehicle:
    maverick
    Wire was in the wrong place. thanks. If you installed it did you notice a difference in the sound of your engine?
     
    wyliedx, Jul 27, 2011
    #3

Share This Page