Yup, had the same problem myself a while back and thanks to this forum and HR-Daddy, problem solved. Spring with stem inside held by the filter.
No, never found out what it was for but I did find one ignition on "hot wire" that I used for a newly placed stereo. If I was to guess, I'd say...
Come to think of it, after taking a closer look at yours, it does resemble mine. Yours just looks like an older type connector. What's the...
Not quite that large, more slim. I'm assuming it might be some type of stereo harness/connector. When I bought the vehicle, it was minus a...
I know it's a 16 pin, but only 8 to 10 wires leading to it. Can't run out and check right now either, am at work. If it is an instrument cluster...
Wondering if anyone can tell me what the 16-pin electrical connector located on the right side of the steering column underneath the dash is for....
I recently replaced mine and yes auto part stores do sell a special socket relatively cheap. Also had to buy some extra plumbing to have the...
After purchasing the Mav, and after tearing into it, I did find an antenna under the dash. It was just the wire with no mast, just laying up...
Just wondering if anyone out there has anything other than a fender mounted antenna? I'm not to keen on drilling a hole in my fender, but if...
I also had a problem with trans lines touching the header on a former vehicle. Tweaked them as best as I could then wrapped them in that header...
Hopefully I can get this pic on here. Not too computer iliterate. Just donnt know where these panels are located in the vehicle.
Anyone have any pictures of these installed on your 2-door Mav?
20 year retired AF here. Was, Am and always will be proud of our military folks.:beerchug:
Got my fittings, elbows, etc. from Ace Hardware this morning. Had to bring the sender up over the fuel pump. Actually looks pretty good :thumbsup:...
Reply They are actual electronic gauges (don't like idiot lights.) Since they are electronic, can I not just use the original sender? I tried...
Got my gauges placed. I need to replace my oil pressure sender with the new one. Problem is it will not fit where the old one is, too big. The old...
Thanks guys. I noticed from your two pics that the earlier models have more room between the radio and the glove compartment compared to my '75....
Anyone have any pics showing your aftermarket gauge setup? Just trying to get some ideas whether to make mine in-dash or under dash, or whatever....
Help: Dist Not confusing at all - I actually feel like a dope because you explained it all too logically. :slap: Thanks for the insight.
Re: Distributor I've never heard of having the rotor lining up with the number 6 plug wire. Where can I find that info? When I was timing my...
Separate names with a comma.
