Clinkin' Lincoln :cool:
[IMG] :hmmm: I dunno where you saw that
Great Photo Op spot too.... I know she's not the Mav but she tries :o [IMG]
i had a mouse run by my head while i was laying on the floor of my mav messin with something under the dash.... I must have looked like a cartoon...
The car is looking great :thumbs2:... Hope my Fuel injected endeavor goes as well as yours is... Good luck on your turbo set up
my '76 block was the same way... i think its just the way they are cast
Everyone needs a few friends like Frank and Jeff. :2thumbs: Had a great time... Hope to see you guys at the stampede
just got back from the upullit and it looks like the crown vic pulley is too stubby and would line up too far forward to work with the original...
i am running a regular early model 302 alternator bracket and standard rotation water pump but i want to use a 6 rib instead of a v belt
:2thumbs:ill go to the local u-pull-it and take some measurements
Earl will probably chime in to correct me if im wrong but i know when he did his t5 swap they cut out part of the bracing for the crossmember...
Got to lookin at the water pump pulley off the early 90s crown vics... it is a 6 rib pulley set up but has two belts without a tensioner instead...
Is it neccesary to install a seperate relay between the factory ignition switch and a late model starter solenoid? in other words.... Can i...
Update: after loosening all the mounting bolts, grinding some of the bolt holes out, and some persuasion.... I got it to line up correctly......
That's a good idea... Thanks I'll try it
That crossed my mind too but the jack rolls freely.... I will double check the motor mounts next time I go to where the car is... Thanks...
http://i1001.photobucket.com/albums/af134/Nickmav70/1261757162.jpg http://i1001.photobucket.com/albums/af134/Nickmav70/1261758948.jpg this how it...
By the way Jeff S, it is a 302... Ignore my signature
It is angled left to right between the frame rails so that the very end of the transmission is offset to the drivers side by about an inch or an...
Thanks everyone.... And merry Christmas :thumbs2:
Separate names with a comma.
