They allow you to adjust for today's radial tires.
I have the roller spring saddles, you're going to like them.
Hmmm, I wonder if you could put one of their sealed flex joints in the lower arm and then box it?
You're right Everett, I had to go look at the instructions that came with mine, I have the same form/date and it does not say anything about...
Here's CJ's listing for the press-in style. They're now made by Dynacorn, same folks that are making the new Mustang bodies in a crate....
All Ford senders up until the mid-80's, IIRC, were the same resistance range, roughly 75-8 ohms.
I have a set of the Moog press in shafts on the shelf, was hoping to get them installed this winter but doesn't look like that's gonna happen this...
Your last two links take me to Amazon "rigid led bar".
Not sure what you mean by "proprietary BMW wiring"? From what I read it's just a 3-pin switch (high. low, and a common ground).
Here's the equivalent of the Volvo relays using two standard 30 amp relays.
I see that dual temperature switch on ebay: http://www.ebay.com/itm/331776051581?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT I...
Frank, what sensor(s) do you use with the Volvo controller?
"close to 5". Would that be 4, Frank? LOL
:Welcome:
Ran into a small hiccup. The FiTech has a coolant temp sensor you have to install and my intake manifold only has one place to screw one in and...
That's why I would voluntarily tell them I have Av gas in it, so they tow the car away.
LOL I have an old car I want to get rid of. I should put some Av gas in it and them tell them that I put it in so maybe they'll tow the POS away!
My homemade controller. The relay on the left has since been changed out for different style relay and the snubbers were added after this was...
Forgot to mention, future plan calls for a bypass toggle switch that I can use to run low speed continuously in case my controller craps out.
Single stage controller. There is a wire under the dash, don't remember the color, that only has power when the key is in the RUN position. I use...
Separate names with a comma.
