gears converters they are all the same ..... NOT Match your cam to your converter, a higher stall is more likely to wipe out that c4 due to heat...
oil pan and headers the only headers That I know fit the 351 for sure is the 6208 hookers and they are $400 in summit racing. any front sump 351...
trans I, until recently ran there 10 thunderbolt converter, it was costing me 4 tenths in my 60 foot times, I am convinced they sell junk avoid...
headers the302 headers dont work becaus of the 1" width difference
Mistakes We should try and learn from other peoples mistakes. In 93 I had a 72 nova with a blown 383 chevy in it with a 9" 31 spline 4.11 and a...
headman I too have the 88300 on my car now and like them but you seem to be forgeting that there is an interferance problem with the passenger...
axles 28 or 31 spline doesnt matter if they arent aftermarket axles then they are weak very week and I do not recomend using a spool with them...
v8maverick v8 maverick you should shoot me your # we can yuck it up about how bad our cars are
Headers I am affraid that only the 6208 hookers work with a 351 they are $400 but are a huge improvement over the standard 1 1/2 or 1 5/8
I am not looking to run bigger than 1 3/4. I will run adapters if need be, I go through the traps at 7200 rpms and run nitrous, it needs big tubes...
spool Get good axles, no one should run a spool or a mini spool without forged axles. the axles are the weak point (but then so is an 8" rear)
What big tube headers are you guys running for the 302 based engines???? must be at least 1 3/4
Headers guys I have the same problem with my Headman 1 5/8 headers I run the new Pro Topline Cyclone aluminum 200 cc heads and it has the raised...
Spool I have always run spools they are cheap an indistructable. and have no wearing parts. Its a no brain'er, Run the spool just be smart about...
what is the best bolt on upgrade for disk brakes, I currently have 4 lug drums in the front, that is the cheapest upgrade, and do you know of any...
REv KIt Back in the day 91 -92 I ran a solid roller rev it in my 69 falcon witha 302 it was a crower or isky rev kit but dont know if they are...
Crank crank can be made to work in a ho block but you need to remember that 289s had longer conecting rods, your 5.0 rods are only 5.090 and 289...
The solution to your problem The solution is a v8 conversion, and a holley with a electric choke. Problem solved
My maverick I am in as well. I will send my paragraph later:bananaman :clap:
set up Just dont confuse a springs ability to take high lift, with its spring pressure rating, the two facts couldnt be farther appart Sounds...
Separate names with a comma.
