4-Speed all the way:comet:
Hi, do I have 10" or 9" rear drums on my 72 302 Grabber? Thanks Tony:drive:
Air/fuel mixture Put a vacuum gauge on the crab and record idle reading when the car is warmed up and the choke is fully open. Adjust the...
:drive:Have you check the motor mounts for loose bolts?. I would hook a vacuum gauge up and run enough hose so you check while drive. 1. Record...
71 Maverick. Need a little more info: 1. Will the engine shake in your driveway in N at 2300RPM? 2. If your driving at 2300 RPM and your car start...
Hi, doing a cam change in my 72 302. I will be using a Crane 272H10. Dose anybody know the torque setting for the rocker arm nuts? Also can I...
Hi, just receive my 4-leaf springs, Dose any body have the specs for the front eye bolt and the body bolt? Do I:drive: need to lube anything...
Step 1. Take your ride back to the mech who put your intake & carb on. Tell them to fix it. It was there mistake. You put down $400.00 for the...
Hi, right now can you get all the power you have to the ground? If you can't then look at some traction bars, shock, frame connectors and...
Hi, I am having brake trouble. My left front is locking up under hard braking causing the car to skid. I have had about 2000 miles of trouble free...
1. All caerbs have a accelerator pump. 2. get a gallon gas can. 3. disconnect you "in side" of the fuel pump hose. 4. put the "in side" of your...
Look for a bad ground cable. Also I would check the pully alignment.
Hi, We will need some info from you: 1. what kind of Carb, intake? 2. dizzy, point or electronic, type of wires, coil? 3. Fuel pump mech, or...
starter short fix!!! :Handshake Thanks guys for your help. I put a new neg. battery cable on and it started the first time I hit the key. Just...
Guys I did not check the starter before I left Auto Zone. What ground strap?.
I drove the 72 Grabber home. Went out 30 min later everything is dead. Tried to jump start, still would not turn the engine over. All light works,...
Looks like a bad timing chain. Pop the dizzy cap off. Line up tdc on the blancer. Turned the dizzy until the rotor was on #1. Lock down the...
Hi, The Real Deal,it a Blue 1972 Grabber. This is what I have done. Put a clear filter on, pulled the needle and seat to check for FOD. It was...
I will pick up a new filter on the way home. Thanks Tony
Hi, I have a 1973 302 auto. Grabber. My 302 has a nice hyd. cam ,ProComp Dizzy, Hooker Headers and Highrise. I put a new 670 cfm Vac Secondary...
Separate names with a comma.
