hello I have a maverick 72 and turn signals not working, everything is connected properly. that could be wrong?
I have a 72 .. I had to replace the Turn signal switch in the wheel... got my part on ebay. make sure the clicker pot is ok first... a very inexpensive item from local store. Warner 552..(I think) there is one for the emergency blinkers and one for the turn signals. Do the emergency blinkers work? then its the pot. I doubt BOTH are bad. If not then you have to pull the wheel (wheel puller) and install a new turn sig sw. harness.. The hard part is getting the wheel off.
the sw of directional and non-emergency work. multimeter with a continuity gave me all the wires to the harness. Therefore I think that still works the emergency button and turn signals, I think it could be a flasher, but I put a new and yet not, maybe I'm missing some gnd? I am leading with this diagram. http://1bad6t.com/Maverick/repair/pdf/72maverickwiring.pdf even remove the protective isolation and disconnect all harnesses to make sure everything was in order but still could not find the fault.
