Looking for a part source

Discussion in 'General Maverick/Comet' started by mav1970, Feb 28, 2009.

  1. mav1970

    mav1970 Bob Hatcher

    Joined:
    Mar 9, 2002
    Messages:
    10,633
    Likes Received:
    322
    Trophy Points:
    398
    Location:
    Mountain Top Pa
    Vehicle:
    69.5 Maverick 393 Cleveland Stroker
    The threaded vent fitting, on my 9 inch rear, that also holds down my rubber brake line block is shot. Does anyone know where I can buy a new one?
     
    Last edited: Apr 29, 2011
    mav1970, Feb 28, 2009
    #1
  2. Dave B

    Dave B I like Mavericks!

    Joined:
    Mar 9, 2002
    Messages:
    16,931
    Likes Received:
    215
    Trophy Points:
    347
    Location:
    Parts Unknown......
    Vehicle:
    3 Grabbers
    National Parts Depot, they list 4 different ones.
     
    Dave B, Feb 28, 2009
    #2
  3. mav1970

    mav1970 Bob Hatcher

    Joined:
    Mar 9, 2002
    Messages:
    10,633
    Likes Received:
    322
    Trophy Points:
    398
    Location:
    Mountain Top Pa
    Vehicle:
    69.5 Maverick 393 Cleveland Stroker
    Yikes! Good thing that I didn't throw the old one out then. Thanks :Handshake
     
    mav1970, Feb 28, 2009
    #3
  4. actionrpm

    actionrpm Differential specialist

    Joined:
    Dec 2, 2005
    Messages:
    409
    Likes Received:
    0
    Trophy Points:
    48
    Location:
    western pa.
    Vehicle:
    '70 mav. '40 Ford Pickup '72 Bronco '06 SuperDuty V-10
    Bob,Too bad your not closer,or you could drive over and I"d give you one,Jack
     
    Last edited: Mar 2, 2009
    actionrpm, Mar 1, 2009
    #4

Share This Page