im trying to take my control valve off of my center link to swap out the ball stud but there is a pin in the way keeping me from unthreading the c.v. off. its not a cotter pin its a barrel? pin. have you guys seen this. i cant seem to pull it off and im tempted to bang it . any suggestions?? how much luck have you guys had taking out the old idler arm bushing? i got the rubber bushing out but the metal "housing" is in there pretty good.
i finally got everything pulled apart. where did you get that pic from? im looking for an expanded detail of whats inside the control valve, im probably gona forget how to put everything back together.
your the man! i have all this stuff in plastic bags lol, i found a guy selling the complete set of shop manuals but have yet to pick them up, glad to see this is in there.
The shop manual will tell you how to remove, rebuild, install, adjust the control arm and also the power steering cylinder or pump...or as far as that goes...any other part on a car.
i was about to put my control valve back together but i dont have the bumper that goes between the spool bolt and the bumper spring.what are the chances of someone having a picture of the bumper?
