Posted by Steve S on January 02, 1999 at 18:13:33:
In Reply to: Front end rebuild question re strut-bar bushings. posted by Steve S on January 02, 1999 at 17:06:01:
Well. After inspection of that piece of frame it's obvious that my idea of removing it was rather naive. :-) The only idea I could get from the counter person at Pep Boys, who apparently owns a maverick or has rebuilt one, was to apply heat and hope it comes loose. Guess I get to try that. Please post any ideas you have incase this doesn't work.
Thanks
Steve
: I'm rebuilding the front end and have discovered that the caps that hold the strut-bar bushings in place are pressed on. I can't get the bloody things off to replace the bushings. Normally I'd just leave them in as they look ok but I paid for the polygraphite stuff and would like to use it. Only thought I've had so far is to try and remove the frame part that they are attached to and take that to a shop to see if they can un-press it for me. Are there any other ideas?????
: Thanks in advance
: Steve