Posted by Ryan (IP: 130.13.65.74) on June 09, 2000 at 04:42:35:
In Reply to: The holes are not for grease zerks... posted by T.L. on June 09, 2000 at 01:45:48:
There are other ways to change upper control arm bushings other than cut holes. There are two bolts that go through the shock tower into the engine compartment, you take those off to change control arm bushings. Once the whole arm is out you can get a wrench on'em and unsrew them and have all kinds of room for them to go. I vote that they are for zerk fittings.