Posted by rickyracer (IP: 209.20.170.45) on August 12, 2000 at 12:28:52:
In Reply to: Versallies Spindle question posted by Mark G on August 12, 2000 at 11:46:14:
Several ways,
1. Call a parts store and see if they have both types in stock, take it down and see which one fits and that'll tell you what you have. Some of the older parts books actually have all the measurements in the back.
2. Check the part numbers and see if Ford did use the same spindle. Actually there's three places you have to worry about, both ball joints and he tie rod end.
What ever you do find out about it, write it sdown for future reference
: I have a pair of spindles that appear to have too large a lower ball joint hole. They were sold to my friend as granada spindles. Does anyone have a measurment of the lower ball joint hole for both versaillies and grananda so we can identify the problem. Is there any other way to tell betweent the two? They are going on a 66 stang. Thanx for the help, I could not find any measurments in the archive.
: Mark G