Posted by Craig Selvey (209.212.216.155) on January 07, 2001 at 21:54:19:
In Reply to: Couple of questions... posted by Richard Parson on January 07, 2001 at 20:50:01:
_____________________________________________
In order to put the 5-lugs on your car, you would need to switch the entire axle, not just the axle shafts. Yes, there are two different bearing sizes between the 4-lug and 5-lug. If you can get the right bearing, than it can be done, but I recommend switching the entire axle. Of course, I am assuming that your 1970 has an 8" in order to switch "just" the axle shafts.
Hope this helps.
==============================================
: 1)Would an 8" rear end have two different bearing sizes or would I not have to worry about that. I have a four lug axles right now. I want to go up to five lug with a different 8". My car is a 1970 Maverick and the donor car would be a 1977 four-door I believe.
: 2)Can I fit a 245/50/16 tire under the front wheel wells if I cut ever so slightly the fender lip? Since I would not want anymore backspacing or offset would the tires stick out too far? Could I cut the inside frame rails any? Lower the upper control arm to clear the rim? I want ultimate performance and am willing to cut up my Maverick to do it. So any suggestions would be appreciated.
: Any help is appreciated