Re: I/6 200 motor rebuild help

[ Follow Ups ] [ Post Followup ] [ Maverick Message Board ] [ FAQ ]

Posted by Steve-S (IP: 24.27.42.12) on October 19, 2000 at 20:47:42:

In Reply to: Re: I/6 200 motor rebuild help posted by Fastman on October 18, 2000 at 19:43:27:

This sounds like it's at least worth looking into. What is the kit # from PAW and what is PAW and do they have a web site?

Thanks
Steve-S

: Your cyl. head should be good since it shouldn't have many miles on it, and if you are very careful you can get away with rebuilding the engine for around $600 as a safe rebuild(not going with cheap parts but not the best either). That is assuming you don't have the head done, but DO have the crank and rods checked by a machine shop, along with the block being checked, cam bearings, freeze plugs installed and bore and hone job. If this sounds good, repost here and I will give you the kit number from PAW that has pistons, cam etc.

Follow Ups:

Post a Followup

Name:
E-Mail:

Subject:

Comments:
: This sounds like it's at least worth looking into. What is the kit # from PAW and what is PAW and do they have a web site? : Thanks : Steve-S : : Your cyl. head should be good since it shouldn't have many miles on it, and if you are very careful you can get away with rebuilding the engine for around $600 as a safe rebuild(not going with cheap parts but not the best either). That is assuming you don't have the head done, but DO have the crank and rods checked by a machine shop, along with the block being checked, cam bearings, freeze plugs installed and bore and hone job. If this sounds good, repost here and I will give you the kit number from PAW that has pistons, cam etc.

Optional Link URL:
Link Title:
Optional Image URL:

[ Follow Ups ] [ Post Followup ] [ Maverick Message Board ] [ FAQ ]