Posted by Steve-S (IP: 24.28.68.29) on September 16, 2000 at 15:52:19:
I have the stearing wheel off and the wiring harness out. I have the ignition lock out of the column (part key goes in). I have the snap ring off. I can't get the bearing off to get the ring that holds the key part off so I can replace the spring behind the column mounted shifter arm. It appears to be pressed on. Do I need to loose up the column in the engine compartment to pull it out some? If so how would I do this? My book doesn't go into getting this deep in the steering column and I'm stumped.
All help appreciated.
Steve-S