Posted by: rickyracer ®
2001/09/01, 14:36:47
Author Profile
|
The aftermarket heads have the same bolt holes in the ends that the factory ones do> That's all you need for mounting using your orginal brackets.
As for sending your heads to Calif. ? You're in the heart of Nascar racing, head work can be found easily just down the road from you. Roush racing is just north of you, Racer Walsh is in Jacksonville, Fl.
:Old Guy and Ricky-
:Right now I have about $275 in the heads with
:1)bare castings
:2)the stainless 1.94/1.6 valves
:3)guideplates and ARP screw-in rocker studs
:
:I have looked at the aftermarket products: cast iron and aluminum. I was seriously considering the Edelbrock(sp?)
:Performer heads for non-emissions ('74 car) but no dealer
:would tell me via telephone or e-mail(couldn't see them
:in person) if my factory A/C and P/S would connect.
:
:I am still looking for someone to do the work on the heads.
:A buddy of mine has talked to a guy in California-we're
:in NC, and he says this guy will assemble bare small block
:heads using his stainless valves, guideplates, screw-in studs,
:port and bowl work and have them ready to bolt on for 'very
:good street performance' for $795 plus shipping to him.
|
