Ok I found a complete used p/s system for my 74'. box, pump, draglink, tie rods and ends, bracket, hoses , ect. To make the swap, are there any...
new motor? Sounds pretty nasty!! Had you run it on a dyno prior to firing it? What are the particulars on your build?
Done !! 1 coil off the frt, 1" blocks in the rear...and we media blasted and repainted the rear, springs and wire brushed the rusty looking tank...
diameter of p-rods The diameter really won't/shouldn't make any difference, but the length sure will. Are any of them longer than the others?...
drop Thanks guys - cut 1 coil and like the results, much better. May try some 1" blocks for the rear and see where we end up.
thanks TL- I'm going to go slow here...first 1 full coil , then reinstall and check how she sits. Maybe another if necessary, but I don't want...
Thanks Paul- you don't happen to know a source for those Mustang blocks do you?
Hey guys- my son and I want to lower our 74 car. Because I bought the car already built, I'm not sure what rear or frt springs are on it, nor does...
valve seals Yes you can... replace them all, new plugs and drop the pan and oil pump as noted above. Clean everything out and reinstall. While...
Checked the damper position today - still looking for that ignition problem. Damper SFI- is at 330* at tdc so 0* represents 30* advance. It will...
Mine misses to bad to find out. previous owner claims 11:64 with 2:30 60 ft times.... but it is that same set up near as I can tell.
blower I've got that exact setup and if I can ever get this ignition issue fixed ,I'll see what it can do. Previous owner claims 11:64 with a...
converter A custom conveter is just that - it custom built to suit your particular set- up as to hp/trans/rear etc. Personally I wouldn't spend...
timning So - I did try to check the timning yesterday and got a fairly steady signal, but, @ idle it read 0* and @ 2800 only 10*. I'm trying to...
pics give me your e-mail address again. B.barrett @ hotmail.com???
bad miss Thanks guys for the suggestions- spent a little more time with MSD tech line today. I have checked the alt output/plugs/plug wires/...
raer ends My wife's fits ....but its a tight squeeze:yahoo:
no - I've been leary of that to this point as its a blown car and I really know nothing about the set up yet- just learning. I have checked the...
carb Dump the e-brock and get your self a nice Holly street avenger.
I have a standard inductive type timning light that has worked fine to date. Today I tried to use it on my Mav w/msd box6bmt/blaster coil/and...
Separate names with a comma.
