Some comment. You have to drop the mounting location quite aways. The farther it is dropped the more leverage is puts on the frame and the...
The electrical path to the coil during starter turn over is different than the RUN circuit. There is a dropping resistor in the run lead. You...
Take a sample of the gas. Slide some between your fingers and see if some one thought your car needed some oil in the gas tank as well. Sounds...
Take a good look at the areas. If you carefully cut the supports so shaped flat plates can be welded back in, the strength should be maintained....
Special hi temp made for the application. The sender bulb replaces the electric temp sender at the front of the intake manifold.
Pans are not interchangable. Push rods different length. Block wider and heavier. Takes all the same transmissions except in some special...
I'm not fully sure of all the issures, but I think you need to use the small 157 tooth wheel with your C4 as it should have the small bell housing...
Track is Silver Spring Seedway , Mechanicsburg about 45 min. from where the car show is. Sat nites. Many drivers come that run the 410 cu/in...
The prices of nearly everything is now slowly going up. The kits used to be around $80. It includes lifters that are a must to break in on a...
If your on a tight budget; like I mentioned, use a factory cast iron 4 barrel. You should not have to spend any more than $50 for one. A Holley...
The problem could be either ignition or fuel supply. A bad fuel pump will cause the same results. The carb runs out of fuel after awhile because...
Unless you need it for state inspection, leave it off. There is vacuum plumbing to remove if your car has it. If the engine is stock and will be...
I have a Kenne Bell on my 5L Lincoln if that helps. Put three different centifigals on a 93 Mustang over a peroid of time. If I get a chance I...
Dave, I had the same kind of ride down the strip at English Town last fall. The 1 to 2 shift broke the right side more than the left and went for...
The Dura Spark does a nice job. The MSD multy spark may be a little smoother starting and running up to 3000 rpm where the multy spark no longer...
Yes, you will have a problem. May have to go to manuel brakes or fab up a smaller vacuum assembly from another car.
Corban, Consider an LED display for the purpose. It will tell you a bad battery, bad connections when trying to start the engine, alternator...
I have this kit in and it shifts easy under light throttle but get on it hard and it firms up to the point of breaking the tires in the 1 to 2...
Just think a little; you already have full manuel control. Just move the grear shift from 1 to 2 to 3 instead of leaving it in D. The shift kit...
You cannot use the EFI unit on a carbed engine. It has no timing advance built in and you can't use the TFI module. Use the 85 and an MSD or...
Separate names with a comma.
