Rounded the front edge, the issue I'm having with the top to passenger side edge is only a elevation change of about a 1/8th inch if that... I'll...
It's close but the top-to-side hammered transitions are not perfectly smooth and consistent like I want it (radius seems the same but the...
Trying to figure out at what point do I stop hammering and use bondo... trying to smooth out the rounded top-to-side transitions and the top...
that is where I'm leaning... roll all the front edges and where the two angles meets in the center give it a small ridge line...
I've been working on a steel scoop like the fiberglass one that was one it. Now I'm trying to figure out how I want to finish the front edge....
working on my hood, filled in holes from my cheap fiberglass scoop, raised the edge where I have a hole cut out for my air filter with my hammer...
yeah I'll probably go with a scoop, easier... otherwise I'll probably try to over engineer it and never get it done... I would probably try to...
Get a K&N filter or equivalent and you should be fine.
As I mentioned earlier I have a couple extra Toyota celica fenders that I thought about using... here is a picture to let you know what I'm...
Either choice scoop or cowl I'll be fabricating it myself, if I go with a scoop it would most likely be the Boss 429 style that I currently have...
I've been wondering which is more preferred Hood Scoop or Cowl Induction... This is a two part question; First, which do you think looks better,...
ok, on a side note how would I change the bulb? from the front?
So... would they disconnect from the bucket on a '74 maverick like the comet one shown above and have the pigtail or is it just the pigtail. thanks.
Alright, for some reason I was expecting it to disconnect from the bucket end... like every other light on the car... thank you.
I installed my front bumper spacer, bumper, rear window trim, painted and installed front valance. tried to remove the grill but the turn...
I've got the grill unbolted from everything else but I can't get the electrical connection to come apart so I can actually remove the grill... I...
Ok I feel like a idiot even asking this but how do I disconnect the front turn signal plug from the grill? I'm trying to get the grill off and...
I thought that to but for the few minutes it takes to unbolt rotate and rebolt I figured why not and like I said it stopped the vibration I was...
Got most of the masking tape off after my krylon paint job, re-assembled the back of the car so I hope the HOA will get off my back. I just wish...
Here is a relatively cheap way to remove one possibility. First, pick up some new u-bolts for your rear driveshaft u-joint to pinion, and Second...
Separate names with a comma.
