I thought the next one was in Washington Pa?
Optimas have been junk for quite some time now Look into odyssey, XS, and or braille batteries
I like the kickback but can't really tell of theirs any baffles or mesh screen above baffles. ....also chrome retains heat..
I would say install a vaporworx kit with camaro/vette pump or aeromotive phantom kit Both will address fuel slosh and pump captivation
CAM-T is where its at Good vids man, keep them comming
Anything you can think of to regain the 5-6 degree turning radius back? Thats one epic fail imo..
Clipping from Bryce I do not like the MII because of the really low roll center and the large RC migration. Camber gain and bumpsteer and not...
No not thickness, just physically not wide enough..more specificly the lower arm Im going off memory so its probably not the whole issue but In A...
..still thinking about this kit But with the design flaws of an M2 ,I'm still leaning towards an AME front clip with C6 suspension.. The main...
yeah for an engine that weighs around 444lbs and puts out 360hp 380 ft lbs for 2k it doesn't seem like a bad route to go..a d it gets modernized
Also i have been reading coyote and mod 4.6 share same bellhousing/ 8bolt crankshaft and flexplate bolt pattern..
Is that a unisteer kit?
Well must not be hard though, read on some forums people running AODs, C4 and gm trans behind the coyote I Got to do more digging it seems
What about a manual valve body for 4r70w Or simply use an AOD from a modular engine?
As for the vss and trans working, it says itll work with a mechanical speedo...so that should eliminate the vss issue .as should a gps speedo...
I guess the other lil snag may be the driveby wire throttle/pedal? Ill check out the other links now
Exactly Just look into the UniSteer R&P kit or R&C Motorsport MII kit and forget about CPP They pretty much just carry Chinese knockoff parts..
I know theirs some guys working on some I take if you guys are retaining the factory ECU setup. and using the matching auto?
Not sure if anyone noticed yet, but they now offer a kit for mod motor and coyote motor http://rcmotorsportsinc.com/rc-107-mod-3/ I first thought...
A cage wouldn't really be safe for a street car But like mentioned cage isn't required for your eta goal.. A 5 point rollbar will work for 10s
Separate names with a comma.
