I am not using the carb I messed on I am using a Carter carb that was remanufactured by Holley and rebuilt in November. I bought it from someone...
I screwed up the rebuild I am using a rebuilt holley remanufactured Carter 1 bbl carb.
Im not sure how to adjust or measure the float but I got the gaskets and everything squared away today and the engine is running alot better but...
So I replaced the float and seat and needle in the rebuilt carb that I got and the car is running again but it's still running rough. There is...
So are you saying I shouldn't get rid of the egr and where could I find the spacer and gasket?
What is the thing that goes in between the carburetor and the engine? I'm not talking about a gasket it's the part that the egr mounts to. A...
i put the new float in the new carb along with the new seat and needle from the rebuild kit but the gasket in between the EGR and the engine is...
Alright so here's the rundown, I rebuilt the carb and put a new float in it, I replaced the distributor cap and wheel and I am still having the...
well i just swapped the carbs so the old one would be on there but the same thing is still happening im going to get a new float and rebuild kit...
would the flywheel from rockauto also work on a 250 cid
I am firmly convinced that the carb is the problem. I just replaced the distributor cap and ignition wheel and it didn't change anything. I've...
my friend came over today and we screwed with the carburetor and we noticed that black smoke is coming out the exhaust and the car still shuts off...
the smoke and the leak stopped later last night after i took it for a drive. the radiator cap is in good shape but the reservoir is kinda low. ill...
i just got the car back from the shop with its brand new exhaust on it :dancing: and the engine is still idling kinda low so i popped the hood to...
What bore will I need for the master cylinder to have and will I be able to get the flywheel from the same car that I get the tranny from?
Would this pedal work: http://summitracing.com/parts/CMB-14-0016 Other than the transmission, clutch kit, flywheel, pedal and master cylinder...
Will the holes for the the pedal mount be factory marked like they are for bucket seats?
I've actually been reading your tech article a lot over the past few days and looks like it's what I will be doing I just didn't want to start...
nope no power brakes. will it be easier to install a hydraulic rather than a cable
I'm going to be swapping out my c4 for a t5 and I'm not sure which clutch would be better cable or hydraulic. What are the pros and cons of each?...
Separate names with a comma.
